- Disconnect the 4-pin connector (marked with a red cable tie) which is connected in the connector holder.
- Connect the charger to a 12 V socket in the car or to a 110/220 V power cable. Never charge the battery while the car is moving as there is a danger of damage to both the charger and the ignition control unit (ICU).
- Connect the charger to the charging connector on the control unit (ICU). Never disconnect the charger when charging from the ICU!!!
- When the charger is connected to the ICU, charging options will be displayed on the touch screen. The default setting by the JetSurf manufacturer is charging of Li-Po battery which is charged in the same way as Li-Ion battery in the ICU. Select one of the charging modes on the display (the parameters of the individual modes are preset by the manufacturer). MODE1: BAL. CHARGE – it is intended for charging after the last ride of the day. Select this mode when charging JetSurf for the first time. Check the default parameters preset by the manufacturer displayed on the screen. MODE2: CHARGE – it is intended for charging between the individual rides. Check the default parameters preset by the manufacturer displayed on the screen. MODE3: STORAGE – it is intended for charging for storage. Check the default parameters preset by the manufacturer displayed on the screen. MODE4: DISCHARGE – discharging, this mode is not used for JetSurfTM.
- When a mode has been selected, press the green button START. The charger will beep and the battery charging will start. The charging progress is displayed on the screen.
If the battery is not connected or it is connected incorrectly or
if there is any other problem, an error message “CONNECTION
BREAK” will be displayed on the screen and the charger will
start beeping. Press START when asked to do so.
T I P: When the CELL button is pressed (F I G U R E 7 ), the display
will show the level of the individual cells – F I G U R E 8.
7. When the battery is fully charged up, the display will read
Li-Po END and the charger will beep twice.
8. The STOP button will finish the charging process.
9. Disconnect the charging connector from the charger and
put the connector cover on back the connector holder.
10. Disconnect the charger from the source.